

Sycamore Township's postwar neighborhoods are in their renovation decades, and most of that work starts in the bathroom. Alluring Glass fabricates and installs custom shower enclosures, glass railings, wine rooms, mirrors, and table tops for Sycamore Township homes and businesses, measured on site and installed in under ten business days.
Frameless enclosures are the largest category of work we do, and in Sycamore Township they usually begin with a hall bath in a 1950s Dillonvale ranch or a Kenwood split-level. We fabricate in 3/8-inch and 1/2-inch tempered glass, hinged doors where clearance exists, and sliding or barn-style doors where a swinging door would collide with a vanity. Neo-angle and corner enclosures handle the compact footprints these postwar floor plans left behind.
Standard clear glass carries a faint green cast from its iron content, and low-iron removes it, which is worth specifying when the tile is pale. Greater Cincinnati water runs moderately hard at seven to eight grains per gallon, so we cover protective coatings and daily care before you pick a finish, and every enclosure is templated on site, because a seventy-year-old tiled wall is rarely plumb.
LEARN MORE about custom frameless shower doors.
Railing work in the township splits into two patterns: the interior stair and half-landing in a Rossmoyne or Concorde Hills split-level, and the rear deck on the deeper lots toward Highpoint and Brecon. A base-shoe channel gives a clean uninterrupted band of glass with no visible hardware above the shoe; standoff pins mount through the face of the panel for a floating look where opening the floor is not practical.
Half-inch tempered glass is our default for interior panels; exterior guards step up to laminated stock, which keeps a broken panel held together in the interlayer rather than scattered across the deck. Every exterior channel gets drainage weeps and stainless or weather-rated fasteners, because Ohio freeze-thaw finds any standing water, and every run is templated on site before anything is cut.
LEARN MORE about glass railing installation.
A wine room is a climate-control job first and a design job second, and in Sycamore Township it usually lands in the finished lower level of a ranch or split-level. We build the enclosure from insulated glass units rather than single panes: two tempered lites sealed around an argon-filled cavity with a low-e coating, so the room-side face of the glass stays above the dew point. A cooled cellar behind single-pane glass sweats, and a sweating wall inside a finished lower level becomes a mold problem.
Doors carry the biggest failure risk in any cellar, so every door we hang gets compression seals on all four sides and hardware sized to keep that seal true for years. Where the collection is the view, low-iron glass earns its upgrade, and shelving is cut from tempered stock specified to the actual bottle load each shelf will carry.
LEARN MORE about custom glass wine cellars.
Vanity and decorative mirrors are cut to the opening and finished at the edge: a polished edge for a clean flat line, a beveled edge for an angled border that catches light, or a seamed edge where the perimeter will be framed. Antique and smoked finishes are in scope for interior feature walls, dining rooms, and cabinet inserts.
Full-wall gym mirrors are the heavier lift, and the township's larger split-levels and finished lower levels order them steadily. A single panel runs about 100 pounds, more than drywall can carry, so solid backing is confirmed before we quote. Panels set on a continuous bottom J-channel, and we read the wall plane before anything is bonded, because a mirror reflects whatever the wall behind it is doing.
LEARN MORE about custom mirror installation.

Every table top we cut starts from a template of the actual furniture, never a nominal rectangle. A quarter-inch tempered panel is the usual spec for a protective topper over a wood dining table or desk, while three-eighths and half-inch stock carry freestanding tops on a pedestal or base. Edge work runs flat polished, pencil polished, or beveled, and clear bumpers keep glass off the wood so moisture never gets trapped against the finish.
Fogged windows make up the rest of this category. Once the perimeter seal on an insulated unit lets go, moisture works into the cavity and hazes the glass between the panes. Replacement rarely means a new window: we measure the failed unit, fabricate a new sealed unit to match, and set it back into the existing sash, with low-e and argon available on the new glass.
LEARN MORE about glass table tops and furniture.
Yes. Frameless enclosures are fabricated to a field measurement, so an out-of-square opening or a five-foot hall bath is handled in the glass and hardware, not by rebuilding the room. Sliding and neo-angle configurations suit compact footprints with no door clearance.
Yes. We serve both sections of Sycamore Township, from Kenwood, Dillonvale, and Rossmoyne up through Highpoint and Brecon, along with the wider Cincinnati metro, the Dayton metro, and Northern Kentucky.
Insulated glass, always. A cooled wine room built with single-pane glass condenses on the warm side, so we specify a sealed two-lite unit with a low-e coating and a compressed door seal. Low-iron glass is a common upgrade for true label and bottle color.
Usually, yes. Fogging between the panes means the perimeter seal on the insulated glass unit has failed, and the sealed unit can be measured, refabricated, and reinstalled in the existing sash. The frame and trim stay in place, with a low-e and argon upgrade available.
We serve all of Sycamore Township, from the Kenwood retail corridor to the quieter streets of Dillonvale, Rossmoyne, and Brecon, along with the wider Cincinnati metro, the Dayton metro, and Northern Kentucky. Shower enclosures, railings, wine rooms, mirrors, table tops, and replacement insulated glass units are all fabricated in house and installed by our own crew.
Tell us what the room needs and we will put a written estimate in front of you, schedule the on-site field measure, and set a firm install date. Call or fill out our contact form to get started.

By Ed! at English Wikipedia, CC BY-SA 3.0, https://commons.wikimedia.org/w/index.php?curid=36144195
Sycamore Township, Ohio is one of Hamilton County's largest townships, arranged in two sections along the I-71 corridor northeast of Cincinnati. The southern section holds the Kenwood, Dillonvale, Rossmoyne, and Concorde Hills neighborhoods around the region's premier retail district, while Highpoint and Brecon anchor the quieter northern section. Much of the housing stock is postwar ranches and split-levels now in their renovation decades, served by the well-regarded Sycamore Community Schools. Downtown Cincinnati is about 20 minutes away via I-71.
Trust your next residential or commercial project to the experts with over two decades of experience serving Cincinnati & Dayton, OH and Northern Kentucky. From custom wine cellars to office partitions and frameless showers, we are ready to make your vision a reality.